Juniper SSG-140-SH Dokumentacja Pobierz pdf (Strona 25)

Default Device Settings  25

Chapter 3: Configuring the Device

5. (Optional) By default, the console times out and terminates automatically after

10 minutes of idle time. To prevent the console from timing out and

terminating automatically, enter

set console timeout 0.

Default Device Settings

Table 4 describes the default interface-to-zone bindings on the SSG 140 device.

Table 4: Default Interface-to-Zone Bindings

Note that the ethernet0/0 interface has the default IP address 192.168.1.1/24 and is

configured for management services. If you connect the 0/0 port on the SSG 140

device to a workstation, you can configure the device from a workstation in the

192.168.1.1/24 subnetwork using a management service such as Telnet. You can

change the default IP address on the ethernet0/0 interface to match the addresses

on your LAN.

The SSG 140 comes preconfigured with three bridge group (/jointfilesconvert/264691/bgroup) interfaces

numbered /jointfilesconvert/264691/bgroup0/0 through /jointfilesconvert/264691/bgroup0/2. Bgroups let you group multiple Ethernet

interfaces together. Each /jointfilesconvert/264691/bgroup constitutes its own broadcast domain and provides

high-speed Ethernet switching between interfaces within the group. You can assign

a single IP address to each /jointfilesconvert/264691/bgroup interface. You can bind a /jointfilesconvert/264691/bgroup interface to any

zone.

Port Label Interface Zone

10/100 Ethernet ports:

0/0 (default IP address is 192.168.1.1/24) ethernet0/0 Trust

0/1 ethernet0/1 DMZ

0/2 ethernet0/2 Untrust

0/3 ethernet0/3 Null

0/4 ethernet0/4 Null

0/5 ethernet0/5 Null

0/6 ethernet0/6 Null

0/7 ethernet0/7 Null

10/100/1000 Gigabit Ethernet ports:

0/8 ethernet0/8 Null

0/9 ethernet0/9 Null

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Brak uwag

Juniper SSG-140-SH Dokumentacja Strona 25