Juniper SSG-140-SH Dokumentacja Pobierz pdf (Strona 13)

Back Panel  13

Chapter 1: Hardware Overview

2. Save the files from the USB storage device to the internal flash storage on the

device with the save {software | config | image-key} from usb filename to

flash command.

3. Stop the USB port with the exec usb-device stop command before removing

the USB storage device.

4. Remove the USB storage device.

If you want to delete a file from the USB storage device, use the delete file

usb:/filename command.

If you want to view the saved file information about the USB storage device and

internal flash storage, use the get file command.

Back Panel

The back panel of the SSG 140 device contains four physical Interface Modules

(PIM) slots and the power panel.

Figure 4: Back Panel of an SSG 140 Device

The following sections describe the elements on the back panel of the SSG 140

device:

 “Physical Interface Module Slots” on page 13

 “Power Switch” on page 14

 “AC Power Appliance Inlet” on page 14

 “Fuse Cover” on page 14

Physical Interface Module Slots

Physical interface modules (PIMs) let you add Ethernet and WAN interfaces to your

SSG 140 device. For information about installing and removing PIMs, see

“Replacing a PIM” on page 38. For more information about PIMs, refer to the PIM

and Mini-PIM Installation and Configuration Guide.

CAUTION: Always execute the exec usb-device stop command before

disconnecting a USB storage device. Disconnecting a USB device without

executing the stop command may cause the device to restart.

PORT 0

STATUS

PORT 1

STATUS

PORT 0

STATUS

PORT 1

STATUS

PIM Slot 1

PIM Slot 2

PIM Slot 3

PIM Slot 4

Power Panel

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Brak uwag

Juniper SSG-140-SH Dokumentacja Strona 13