Juniper WLA522E Przewodnik Instalacji Pobierz pdf (Strona 9)

Wireless LAN Access Point WLA522 and WLA522E Quick Start Guide Part Number: 530-042353 Rev.01

Additional Radio Safety Advisories

Cabling Requirements

Category 5 cable with straight-through signaling must be installed at the site before you install an AP. A single

connection requires one cable. A dual-homed connection requires two cables.

Mounting an AP on a solid surface requires Cat 5 cable that does not have strain relief. For installation on all

other surfaces, use a Cat 5 cable with or without strain relief.

Warning: In the U.S., locate the AP and any externally attached antennas a minimum of 50cm (19.7

inches) away from people. This safety warning conforms with FCC radio frequency exposure limits for

dipole antennas such as those used in the AP.

Warning: Do not operate the AP near unshielded blasting caps or in an otherwise explosive

environment unless the device has been modified for such use by qualified personnel.

Warning: Before using a wireless device in a hazardous location, consult the local codes, national

codes, and safety directors of the location for usage constraints.

Warning: Do not touch or move the AP when the antennas are transmitting or receiving.

Warning: Do not hold any radio device so that the antenna is very close to or touching the face, eyes, or

other exposed body part while the radio antenna is transmitting.

Warning: Do not connect or disconnect cables or otherwise work with the AP hardware during periods

of lightning activity.

Informational Note: The AP is intended for indoor use only. Do not install the device outdoors, unless

you install it with a Juniper Networks outdoor AP enclosure.

Informational Note: To reduce the possibility of connection interference caused by dust, clean the Cat

5 connector pins before inserting a cable into an AP.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Brak uwag

Juniper WLA522E Przewodnik Instalacji Strona 9